Camshaft Adjustment BMW E60 E87 E90 F10 F20 F30 Petrol Outlet Unit Wheel 7522290

Camshaft Adjustment BMW E60 E87 E90 F10 F20 F30 Petrol Outlet Unit Wheel is an original component from the Camshafts group, designed for BMW petrol engines equipped with the VANOS variable valve timing system on the exhaust side. This used OEM component ensures proper timing characteristics, stable engine operation, and correct integration with the factory engine control unit.

Specifications and technical data

• SKU: 7583208-1
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7583208
• Substitutable numbers: 11367583208, 7583208, 11367522290, 7522290
• Fuel type: Petrol
• Category: Camshafts

Purpose and function in the timing system

The camshaft gear with the exhaust VANOS variator is responsible for the precise adjustment of the exhaust camshaft timing in a petrol engine. This allows the engine control unit to dynamically correct valve opening and closing angles, which results in:

• more efficient cylinder filling and scavenging across the entire RPM range,
• more linear torque delivery,
• better throttle response at low and mid-range RPM,
• reduction of engine knocking and improved idle smoothness.

A properly functioning exhaust-side variator is crucial for maintaining factory performance parameters and emission standards in modern BMW petrol engines.

Benefits of using an original VANOS camshaft gear

Using an original camshaft gear with the VANOS mechanism instead of a worn-out part allows for the restoration of correct synchronization between the camshaft and the crankshaft. In practice, this means:

• stable idle speed without unwanted fluctuations,
• reduced tendency for jerking and power loss in the lower RPM range,
• more predictable timing control system operation during rapid acceleration,
• reduced risk of camshaft correlation errors appearing in the engine control unit.

The used OEM component retains its factory geometry and operating characteristics, which is particularly important in petrol engines with advanced valve timing control.

Condition, verification, and installation aspects

The offered exhaust VANOS camshaft gear is sourced from dismantling and is classified as used, allowing for an economical repair while maintaining original build quality. Before being listed for sale, the component is visually inspected for mechanical damage, excessive gear wear, and the integrity of the variator housing.

During installation, it is recommended to:

• use appropriate timing locking tools in accordance with the BMW service procedure,
• check the condition of the timing chain and guide rails,
• use new fasteners where required by the service documentation,
• perform a VANOS system adaptation and clear any potential errors in the engine control unit after installation.

Why choose an original used component

For such a precise sub-assembly as a camshaft gear with a VANOS variator, using an original component from dismantling is often a more beneficial solution than installing an unreliable aftermarket replacement. You receive a part designed specifically for a given engine type, with proven compatibility with the control system and factory engine maps.

If you want to better understand why original used drivetrain components are a sensible investment, check out the article Humming differential? Find out why a used OEM drive axle is a better investment than an unreliable replacement, where the advantages of using OEM components in the drivetrain are discussed in more detail.

Expanding your BMW timing system service

If you are planning a comprehensive repair or upgrade of your BMW engine area and need other elements from the same group, such as additional camshaft gears, camshafts, or phase control components, check out the available parts in the BMW Camshafts category.