BMW F10 F11 Rear Bumper PDC Wiring Loom Cable Harness F01 F12 9336380

BMW F10 F11 Rear Bumper PDC Wiring Loom Cable Harness F01 F12 is an original electrical installation component designed to support the rear parking system in BMW 5 Series F10/F11 models. Thanks to its factory design, the wiring harness ensures proper connection of the PDC sensors to the control module, which translates into stable operation of the parking assistant. This solution is dedicated to users who want to maintain consistency of the installation with the factory BMW specification.

Specifications and technical data

• SKU: 9336380
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 9336380
• Substitutable numbers: 61119336380, 9336380, BG
• Location on the vehicle: Rear
• Category: Wiring Harnesses, Cables & Connectors

Purpose and function in the vehicle

The presented wiring harness belongs to the Wires, harnesses and connectors group and is designed for installation in the rear part of the vehicle body. It is responsible for transmitting signals between the parking sensors and the rest of the electronic system, which enables precise detection of obstacles behind the vehicle. Its rear placement allows for direct connection to factory mounting points and original BMW installation connectors.

Construction and compatibility with the PDC system

The wiring harness has been constructed as an OEM component, matched to the electrical architecture of the BMW 5 Series F10/F11. Properly selected connectors, wire cross-sections, and cable routing layout allow for maintaining proper communication with the PDC sensors and minimize the risk of signal interference. As a result, the parking system can operate stably, without errors resulting from improper wiring.

Benefits of using an original BMW wiring harness

Using a dedicated PDC sensor wiring harness in the rear of the vehicle allows you to:

• maintain installation compliance with factory BMW standards,
• limit the need for electrical modifications and connector adjustments,
• preserve aesthetic cable routing within the bumper and the rear part of the body,
• reduce the risk of parking system errors appearing after bodywork repairs or bumper replacement.

For users who value consistency with the original installation and predictable PDC system behavior, such a wiring harness is a practical service solution.

Component condition and service application

The product comes from the BMW parts group and is intended primarily for service applications: replacing a damaged wiring harness after a collision, repairing the rear bumper, or restoring the efficiency of the parking system after interference with the installation. The used component allows for economical repair while maintaining the original electrical specification of the vehicle.

If you want to better understand the quality and durability of second-hand components and dispel any doubts regarding their use, check out the article Used car parts: myths and facts you need to know, where the most common concerns of drivers are discussed in detail.

If you are planning a comprehensive repair or upgrade of the rear zone in your BMW and need other components from the same group, such as additional harnesses, wire sections, or PDC installation connectors, check out the available parts in the BMW wires, harnesses and connectors category.