Ford Kuga Rear Wheel Arch Splash Guard Cover Panel Right O/S LJ6B-A104C20-CB

Ford Kuga Rear Wheel Arch Splash Guard Cover Panel Right O/S is a practical body protection component that shields the rear right wheel arch area from water, mud, and small stones. Thanks to its factory-fit design for the Ford Kuga, it ensures a consistent look with the body lines and stable mounting. It is a functional solution for drivers looking to reduce bodywork dirt and improve daily driving comfort.

Specifications and technical data

• SKU: LJ6B-A104C20-CB
• Mark: Ford
• Condition: Used
• OEM Part Number: LJ6B-A104C20-CB
• Substitutable numbers: LJ6B-A104C20-CB, LJ6BA104C20CB
• Location on the vehicle: Rear, Right
• Part type: Splash Guard
• Category: Splash Guards & Mud Flaps

Purpose and fitment

The presented splash guard is designed for installation on the rear right side of the Ford Kuga body. The placement on the vehicle Rear, Right means that the component operates in an area particularly exposed to water, road salt, and debris thrown from under the wheel, which is why its proper fit is important for both paint protection and chassis components. As a part from the Splash Guards group, it works with factory mounting points, which facilitates installation and allows for maintaining the original wheel arch geometry. The properly selected profile of the splash guard helps reduce water spray onto the tailgate and side body panels.

Protective function and benefits of installation

The use of the rear right splash guard in the Ford Kuga affects several key areas of vehicle operation:

• reduction of the stream of water and mud thrown from under the wheel onto the bodywork,
• reduced risk of corrosion in the lower parts of the fender and sills,
• better protection of suspension and chassis components against small stones,
• more orderly flow of debris in the wheel arch zone. Thanks to this, the splash guard constitutes a practical addition to the factory equipment, especially in cars used on roads with poor surfaces or in conditions of frequent rainfall.

Characteristics of the used component

The offered splash guard comes from the secondary market, which allows for an economical replacement of a damaged or missing part while maintaining the original design. The used component is a reasonable choice for drivers looking for factory fitment at an attractive price, without the need to resort to aftermarket replacements with uncertain geometry. By choosing the splash guard from this offer, you gain a component with parameters consistent with the solutions used by the vehicle manufacturer, which facilitates installation and allows for maintaining a consistent look of the entire rear axle.

Practical installation tips

When installing the rear right splash guard in the Ford Kuga, it is worth paying attention to:

• the condition of the mounting points in the wheel arch and the lower part of the fender,
• the correct positioning of the splash guard edge relative to the tire and bumper,
• even tightening of the fasteners to avoid material stress. Careful installation allows you to fully utilize the protective function of the splash guard and reduce the noise generated by water and gravel hitting the bodywork. If you are planning a comprehensive repair or upgrade of the wheel arch area in your Ford and need other components from the same group, such as additional covers, rear splash guards for the opposite side, or supplementary protective aprons, check the available parts in the Ford Splash Guards category. More practical advice on vehicle operation in demanding conditions and ways to save on component replacement can be found in the article Summer heat vs. cooling system: used radiators and fans as a guarantee of savings, which will help you better plan your car's service.