Seat Leon Cupra 1p PDC Parking Sensor Candy White - B9A / F9E 3C0919275S

Seat Leon Cupra 1p PDC Parking Sensor Candy White is an original component from the Parking sensors group, designed for operation in the rear zone of the vehicle. Thanks to its factory finish in Candy White - B9A / F9E, it allows for an aesthetically pleasing and technically correct replacement of a damaged sensor without interfering with the bumper's styling.

Specifications and technical data

• SKU: 3C0919275S-CAN
• Mark: Volkswagen
• Condition: Used
• OEM Part Number: 3C0919275S
• Substitutable numbers: 3C0919275S, 3C0 919 275 S
• Location on the vehicle: Rear
• Color: Candy White - B9A / F9E
• Rim width: 8
• Category: Parking Sensors

Purpose and function of the parking sensor

The presented PDC sensor is designed to work in the rear part of the body, where it is responsible for precise obstacle detection during maneuvering. It integrates with the factory parking assistance system, sending a feedback signal to the controller, which is then processed into acoustic or visual signals in the driver's cabin.

A properly selected element from this group allows you to restore the correct operation of the parking assistant, reduce the risk of bumper damage, and improve the comfort of daily car use in tight urban spaces.

Color and visual fit

The sensor is factory-finished in the Candy White shade marked with paint codes B9A / F9E, which enables a consistent match to the bodywork in this color without the need for additional painting. This solution minimizes installation time and eliminates the risk of tonal differences between the sensor and the bumper surface.

By maintaining the original color specification, the element blends well with the body line, and the parking system remains visually discreet while maintaining full functionality.

Technical characteristics and installation

The sensor belongs to the Volkswagen OEM component group, which means compliance with factory manufacturing standards and operating parameters. Its designation for the rear zone of the vehicle facilitates the identification of the correct mounting location and reduces the risk of errors during replacement.

The element is prepared for installation in the existing bumper socket, using the factory electrical harness. In practice, this translates into a plug-and-play installation in a vehicle that uses this type of solution from the factory, without the need for installation modifications or additional housing adjustments.

Condition and benefits of choosing a used sensor

The offered parking sensor is a used item, which allows for an economical repair of the PDC system while maintaining the manufacturer's original specifications. A properly selected component of this type represents a reasonable compromise between cost and functionality, especially in the case of vehicles used on a daily basis.

Choosing an original used sensor from this group reduces the risk of compatibility issues that may occur with replacements of ambiguous operating parameters, while simultaneously allowing you to maintain the consistency of the vehicle's electronic system.

System expansion and selection of other elements

If you are planning a comprehensive repair or upgrade of the parking assistance zone in your Volkswagen and need other elements from the same group, such as additional sensors, mounting elements, or connection harnesses, check the available parts in the Volkswagen parking sensors category.

When deciding to install a used sensor, it is worth reading practical tips regarding the selection of automotive electronics – the article Second life of electronics – when is it worth choosing used engine controllers, comfort modules, and parking sensors? will be helpful, where you will find a discussion of key technical and operational aspects.