Mercedes Vito W639 Drive Shaft Rear Axle Output Manual Transmission A6393502310

Mercedes Vito W639 Drive Shaft Rear Axle Output Manual Transmission is a drivetrain component designed for the rear axle in Mercedes Vito W639 generation vehicles with a manual transmission. This used drive shaft from this series ensures a factory-fit to the axle and hub assembly, which facilitates installation and allows for maintaining predictable drivetrain performance parameters.

Specifications and technical data

• SKU: A6393502310-1
• Mark: Mercedes (Genuine OE)
• Condition: Used
• OEM Part Number: A6393502310
• Substitutable numbers: A6393502310, A 639 350 23 10
• Location on the vehicle: Rear
• Gearbox type: Manual
• Category: Driveshafts

Purpose and function in the drivetrain

The described rear drive shaft operates within the driven axle, transferring torque from the final drive to the road wheel. The design, adapted for rear placement in the vehicle, ensures proper cooperation with the suspension and mounting elements characteristic of the Vito W639. This solution is particularly important in commercial vehicles, where the drivetrain is regularly subjected to loads during cargo transport.

Compatibility with manual transmission

The drive shaft has been designed to work with a manual transmission system, which is significant for the geometry of the joints and the characteristics of dynamic load transfer. In practice, this means it is matched to the typical operating conditions of a Mercedes Vito W639 with a manual gearbox, both in urban traffic and on longer routes under load.

Application in the rear axle – right and left side

The product is intended for installation in the rear part of the vehicle, with the possibility of use on the right or left side, depending on the configuration of the specific unit. This solution facilitates the selection of parts during drivetrain repairs when it is necessary to replace the drive shaft on one side or symmetrically on both sides of the axle.

Characteristics of the used part

The item comes from disassembly, which allows for an economical repair of the drivetrain while maintaining the original manufacturer's specification. A used drive shaft is a good choice in situations where compliance with the factory design is important, while at the same time controlling service costs in a commercial vehicle such as the Mercedes Vito is a priority.

Selection and diagnostics in the context of the drivetrain

When replacing a drive shaft in a Mercedes Vito W639, it is worth paying attention to the general condition of the drivetrain – including the clutch, final drive, and cooperating elements. A guide on diagnostics and component selection in the drivetrain may be helpful, available in the article Clutch and dual-mass flywheel – diagnostics and selection of parts for the drivetrain, which discusses the practical aspects of the entire drivetrain operation.

If you are planning a comprehensive repair or upgrade of the drivetrain area in your Mercedes and need other elements from the same group, such as shafts, joints, or intermediate elements, check the available parts in the category Mercedes drive shafts.