Door Lock BMW i3 I01 System Latch Front Right O/S Lower Door Catch 7291032

The BMW i3 I01 Front Right Door Lock is a precise component from the Doors and Door Panels group, designed for the front right side of the vehicle body. This used factory lock ensures proper cooperation with the handle mechanism, latching, and electrical system, contributing to the secure and stable closing of your BMW i3 I01 doors.

Specifications and technical data

• SKU: 7291032
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7291032
• Substitutable numbers: 7291032, 51227291032
• Location on the vehicle: Front, Right
• Category: Doors & Door Skins

Intended Use and Vehicle Placement

The presented lock is dedicated for installation in the front passenger side area, guaranteeing a proper fit with the door and body pillar construction. Its placement in the front-right section means the component has been designed for specific cable routing, strikers, and electrical harness, which simplifies installation and reduces the risk of adjustment issues.

Thanks to its original body geometry and mounting points, the lock works with original hinges, external and internal handles, and door seals, maintaining the correct body line and sealing when closed.

Technical and Functional Characteristics

As a component from the Doors and Door Panels group, the lock is responsible for several key operational functions:

• mechanical latching of the door leaf to the car body,
• stable guidance of the lock bolt during closing,
• cooperation with the handle mechanism and control cables,
• proper response to forces acting during door opening and closing.

The original design ensures adequate body rigidity, which minimizes play and unwanted vibrations during driving. The lock is prepared for operation in typical BMW i3 I01 operating conditions, considering the loads resulting from frequent door opening and closing, as well as ambient temperature changes.

Condition of the Component and Benefits of Choosing a Used Part

The offered door lock comes from the used parts segment, allowing for a reasonable purchase cost while maintaining factory assembly specifications. A used component of this type is particularly attractive for post-accident repairs or replacement of an operationally worn-out part, where correct mechanism operation and fit with existing door hardware are priorities.

Choosing an original, used lock helps reduce the risk of compatibility issues that can arise with unverified or questionable origin parts. This is a practical solution for users who expect predictable installation and preservation of the mechanism's factory operating parameters.

If you want to better understand the differences between original parts, aftermarket parts, and used parts, as well as their long-term cost-effectiveness, it's worth reading the guide on selecting original, aftermarket, and used car parts.

Selection, Installation, and Application in BMW

The lock has been developed with the specific door construction of the BMW i3 I01 in mind. Therefore, with proper selection regarding the body version and installation side, a plug-and-play principle is possible, without the need for modifying mounting holes or running additional wires. In practice, this means:

• easier alignment with the door panel and pillar,
• correct positioning relative to the body striker,
• preservation of the handle and cable's factory range of motion.

During replacement, it is recommended to check the condition of the hinges, seals, and adjust the door's position relative to the body to fully utilize the capabilities of the newly installed lock and avoid excessive stress on the mechanism.

Expanding Door Area Repairs in BMW

If you are planning a comprehensive repair or upgrade of the door area in your BMW and need other components from the same group, such as panels, reinforcements, or additional mounting elements, check the available parts in the BMW Doors and Door Panels category.