BMW F44 Gran Coupe Seal Door Rear Right O/S Shaft Gasket Rubber 7483106

BMW F44 Gran Coupe Seal Door Rear Right O/S Shaft Gasket Rubber is an original component from the Door seals group, designed for installation on the rear right side of the vehicle body. It ensures a tight seal between the inner door edge and the bodywork, reducing noise, vibrations, and moisture ingress into the vehicle interior. Using this OEM component allows you to maintain factory fitment and cabin finish consistency.

Specifications and technical data

• SKU: 7483106
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7483106
• Substitutable numbers: 51357483106, 7483106
• Location on the vehicle: Rear, Right
• Category: Door Seals

Purpose and technical function

The presented seal is dedicated to the rear right door of the BMW F44 Gran Coupe series. Its task is to create a continuous, flexible barrier between the door and the bodywork from the interior side, which results in:

• reduction of wind noise when driving at higher speeds,
• limiting the ingress of moisture and contaminants into the sill area,
• stabilization of the door upholstery and trim elements,
• maintaining proper pressure of the door leaf against the body.

Thanks to its factory profile and geometry, the seal works with the Gran Coupe door construction, maintaining the body rigidity and acoustic comfort characteristic of BMW.

Benefits of using an original seal

Using an original sealing strip in the rear right part of the body allows you to avoid problems typical of aftermarket replacements with inaccurate profiles. The component ensures:

• secure fitment with factory mounting points without the need for modifications,
• visually consistent seal edge alignment relative to the other doors,
• stable adhesion along the entire length, which reduces rattles and looseness,
• maintenance of the manufacturer-designed sealing line in the rear seat area.

The used OEM component is a good choice for post-accident repairs, replacement after wear and tear, or when eliminating leaks and noise in the rear part of the cabin.

Installation characteristics

The inner door seal strip is designed for installation in the area of the rear right door. The construction provided by the manufacturer allows for:

• restoring the factory sealing path along the entire door edge,
• correct positioning of the seal cross-section relative to the door frame and pillar,
• maintaining proper pressure after closing the door, without excessive resistance.

Selecting the correct component for the specific side and axle of the vehicle is crucial for maintaining the symmetry of door operation and even distribution of pressure forces around the door opening perimeter.

Condition and service application

The offered seal comes from dismantling and has the status of a used component, which allows for an economical repair while maintaining the original BMW specification. This type of element is particularly useful in situations where:

• the existing seal is deformed, cracked, or leaking,
• after bodywork and paint repairs, it is necessary to restore the factory sealing line,
• there is noise in the area of the rear right part of the body, difficult to eliminate by adjusting the lock.

Choosing an original seal for a specific model and side of the vehicle minimizes the risk of further service intervention in this area.

If you are planning a comprehensive repair or upgrade of the door area in your BMW and need other elements from the same group, such as inner sealing strips, perimeter door profiles, or additional buffers, check the available parts in the BMW Door seals category.

To better understand the impact of the condition of body and suspension elements on driving comfort and handling precision, it is worth reading the guide: Suspension knocking? Discover a clever way to restore factory handling precision without spending a fortune at the service center.