Audi A6 C6 Weather Strip Cover Panel Trim Rear Right O/S 4F5853268E

Audi A6 C6 Rear Right Seal Cover Trim Strip is an original body part designed for the right rear section of the vehicle, providing an aesthetic and functional finish to the seal edge. Thanks to its factory fit to the Audi's construction, the trim strip ensures proper seal guidance and stable mounting in the rear body area. This is a practical solution for users who want to restore the correct appearance and sealing of this body zone.

Specifications and technical data

• SKU: 4F5853268E
• Mark: Audi
• Condition: Used
• OEM Part Number: 4F5853268E
• Substitutable numbers: 4F5853268E, 4F5 853 268 E
• Location on the vehicle: Rear, Right
• Category: Other Exterior Parts & Accessories

Purpose and Function of the Part

The rear right seal cover trim strip operates in the rear right section of the body, where it is responsible for guiding and covering the seal. When properly installed:

• it stabilizes the seal in its designated track,
• it reduces the risk of it rolling up or coming loose,
• it supports maintaining the seal in the rear zone of the vehicle,
• it visually tidies the body edge where it meets the seal.

Thanks to its factory geometry, the part is tailored to the body lines of the Audi A6 C6, which facilitates installation and helps maintain a cohesive look of the entire rear of the vehicle.

Compatibility and Fit for Audi

The product comes from the Audi range, which means compliance with factory dimensional and mounting standards for this model. The part is designed for installation in a specific location – the rear right side of the vehicle – so when selecting it, pay attention to:

• body generation compatibility (A6 C6),
• vehicle placement (rear, right side),
• type of rear body configuration (sedan/avant – according to the car's configuration).

Such a precise fit helps avoid installation problems and ensures correct alignment with adjacent body parts and the seal.

Performance Characteristics and Installation

As a body part operating in the rear of the vehicle, the trim strip is exposed to operational stresses such as temperature changes, moisture, and minor stresses resulting from body flex. Using an original component helps maintain:

• material consistency with other body parts,
• appropriate rigidity and flexibility in the area of contact with the seal,
• an aesthetic edge finish, without unnatural gaps or deformations.

A used part is a good solution for post-accident repairs or replacement of worn components when you want to maintain the original construction at a reasonable cost. Factory origin promotes trouble-free installation in place of a damaged trim strip, without the need for modifications.

Why Choose an Original Audi A6 C6 Trim Strip

Choosing an original seal cover trim strip for the rear right section of the Audi A6 C6 primarily means:

• guaranteed fit for the specific model and body version,
• maintaining the factory body line and a cohesive look of the car's rear,
• proper guidance and support for the seal in a critical area,
• the ability to restore proper sealing after body repairs.

For users who care about the technical correctness of repairs and the aesthetics of the body, using such a part is a practical way to maintain the proper condition of the vehicle's rear zone.

If you are planning a comprehensive repair or upgrade of the rear zone in your Audi and need other parts from the same range, such as covers, trim strips, or small body finishes, check the available parts in the Other Audi category.

To better understand the structural differences between various versions of this brand's models and the impact of applied solutions on operation, it is worth reading the article Audi RS vs Other Models – What's Under the Hood and Chassis?, which discusses key aspects of Audi car construction and equipment.